Property could not be read from database; using default values

Navigation:  Messages > Design-Time Messages > General >

Property could not be read from database; using default values

Previous pageReturn to chapter overviewNext page

Cause : This message occurs, when opening a Script, if one of the ScriptLine Properties cannot be initialized properly using the information stored in the database the last time that Script was saved. Consequently, to allow the rest of the Script to be loaded, Q++ ignored the saved values for this property and used default values.

 

Consequence : The settings you originally specified for this property will need to be reset.

 

Solutions :

 

Remove this Warning : Once you have manually reset this property (which is selected and highlighted when you click on the original message), then you can click on this proposed solution not to be warned about it again. If, you did not reset this property immediately, then you should not click on this proposed solution, so that the warning remains there as a reminder.


Topic 177040 updated on 30-Dec-2005.
Topic URL: http://www.qppstudio.net/webhelp/index.html?propertycouldnotbereadfro.htm