Unknown SCAN command number !

Navigation:  Messages > QuarkXPress Messages > Scanning/Inspecting Messages >

Unknown SCAN command number !

Previous pageReturn to chapter overviewNext page

This internal error message is generated if QuarkXPress determined that the pCode it is being given tells it to scan, but then is unable to determine which of the scanning variants it is supposed to perform.


This message should never occur. If it does, please contact technical support, being sure to mention the error message ID listed at the bottom of this topic.

Topic 180640 updated on 31-Jan-2019.
Topic URL: https://www.qppstudio.net/webhelp_xv4/index.html?unknown_command_number.htm